|
Post by jseevers on Sept 5, 2008 0:41:28 GMT -8
Has anyone swapped a 2TC motor and 5 speed into a Corona that came with a 3RC with a toyoglide? If so what kind of fabrication am I looking at doing? I know I could figure it out myself but I just wanted to see if anyone had any advice on it before I dig in.
|
|
Gerry
Toyota Fan
AKA" lisasdecals
Posts: 55
|
Post by Gerry on Sept 9, 2008 6:43:53 GMT -8
You have to modify your X member to sit the engine correctly. The 2tc " I believe has a front sump" and it will not sit correctly . Here is a picture of my Corona project. I am installing a 4AGE. Notice how we cut out around 9 inches to sit the motor. You have to modify the mounts and also modify the transmission mount and driveshaft . Hope this gives you an idea.
|
|